Clean + Easy Non-Laser Personal Electrolysis Hair Removal for Face & Body

Clean + Easy Non-Laser Personal Electrolysis Hair Removal for Face & Body is an economical system that provides professional results at home. This system can be used on the face and body. Perfect for gentle fast and safe removal of unwanted hair.

Directions

Set Comfort Control Dial to position one. Push the slide button forward to expose the stylet tip. Hold the stylet like a pen with fingers around touchband. Be sure your fingers are moist (not dripping wet) throughout use to ensure circuit is complete. Overly wet fingers will cause unsatisfactory results. Do not squeeze skin adjacent to the hair being removed. Excessive pressure will cause skin damage. Note angle of hair growth insert the stylet tip along the underside of the hair and into the follicle.

Use only downward pressure as sideways pressure will bend the tip. Hold the stylet tip firmly in place. When proper contact has been made you will feel a tingling sensation. If you do not feel a slight tingle with
the Comfort Control Dial set at mid-range gradually increase the setting until a tingling sensation is felt. This indicates that the current is flowing. In addition try gently rotating the stylet tip in the follicle a few times to make sure you are contacting the hair root.

When you feel slight tingling hold the stylet firmly in place and count to 15 slowly. This will indicate that you have treated the hair for approximately 15 seconds. Remove stylet and use tweezers to gently remove the hair. If the hair resists or if the skin “lifts” reinsert the stylet and treat for another 15 seconds. Treatment time will also vary depending on the position of the Comfort Control Dial and upon the area you are treating.
Experiment until you find your treatment cycle but do not treat for more than two 15-second cycles at a single sitting. Overly moist fingers or excessive treatment may cause “pitting” of the skin which may lengthen the healing process. Once treatment is completed remove the hair with tweezers. Should you experience any resistance the root has not been destroyed. Repeat treatment after 48 hours.

Electrolysis has been successful when hair can be removed with tweezers without resistance. Treatment time may vary between individuals and depends on the area being treated. Always keep tweezers handy to avoid having to take your eyes off the treated area. After treatment clean skin with isopropyl alcohol once again. Do not apply make-up perfume or expose treated areas to the sun for 24 hours.